EFEKTIFITAS PEMAKAIAN DAYA PADA PROTOTIPE ESKALATOR DENGAN PLC DAN NON - PLC
(1) Universitas Negeri Padang  Indonesia
(2) Universitas Negeri Padang  Indonesia
(3) Universitas Negeri Padang  Indonesia
Corresponding Author
DOI : https://doi.org/10.24036/voteteknika.v2i2.4061
Full Text: Language : en
Abstract
The research begining from the real in the Department Store and Mall so many to see Escalator that is a tool can be bring object from under floor to upper floor or opposite. Escalator always on from begining the mall open until with the mall close everydays certainly need too big power and money must be buying every month for that power used. Programmable Logic Controller ( PLC ) is a digital electronics system / special type control have as a base microprocessor using the memory can be program for saving the instruction – instruction and order the tool will be control. Seen the symptom then can be formula the problem in this research that is how to abate power used escalator in the mall city of Padang involve the use of tool controlling that is PLC pass through of analysis of escalator prototype. Type this research is a experiment in the research researcher try to observation and manipulation the research object with a control. Researcher do at act of planning program, escalator with PLC control and measurement used power of this escalator prototype and comparable with escalator prototype without PLC control in this prototipe. The result seen that escalator prototype non – PLC needed the power in 3 hour ( 116,84 Ampere ) too high if compare with escalator prototype with PLC is (62,65 Ampere ). Like that with torque when no load 0,5 Nm for prototype non – PLC but 0 Nm for prototype with PLC and speed 413 Rpm for escalator prototype non – PLC than 400 Rpm for escalator prototype with PLC when the load 2,5 Kg.
Keywords :Escalator, Programable Logic Controller (PLC), LimitSwitch
Article Metrics
Abstract Views : 648 timesPDF Downloaded : 201 times
Refbacks
- There are currently no refbacks.