Pengaruh fraksi konsentrasi nanokomposit Fe3O4/PANi dengan metode sol-gel spin coating untuk material elektroda baterai lithium (Effect of Fe3O4 / PANi nanocomposite concentration fraction by sol-gel spin coating method for lithium battery electrode material )

Varadila Sahanaya - Jurusan Fisika, Universitas Negeri Padang, Sumatera Barat, Indonesia
- Ramli - Jurusan Fisika, Universitas Negeri Padang, Sumatera Barat, Indonesia
Yenni Darvina - Jurusan Fisika, Universitas Negeri Padang, Sumatera Barat, Indonesia

Abstract


In this modern era, technological developments in the field of electronic devices are progressing very rapidly. Therefore, this triggers the demand for storage of electrical energy, one of which is a lithium battery. The performance of the lithium battery depends on the electrode material used. The purpose of this study was to investigate the effect of Fe3O4 concentration on Fe3O4/PANi nanocomposite electrical properties by sol gel method for lithium battery electrode material. In this study, the growth of Fe3O4/PANi nanocomposite layers using spin coating method with a concentration variation of 30%, 40%, 50%, 60% and 70%. Magnetite was prepared using sol-gel technique with precursors (Fe(NO3)3.9H2O). Then the precursor was mixed with PANi polymer with varied concentrations. The results of Fe3O4/PANi Gel are coated on a glass substrate followed by a drying process. Fe3O4/PANi nanocomposite layers were characterized using X-Ray Diffraction and Scanning Electron Microscopy and LCR meters. The results of this study indicate that at a concentration of 30% to a concentration of 40% there is a decrease but at a concentration of 50% an increase in the size of the crystal and at a concentration of 60% to 70% decreased again. FTIR results show the molecular bond formed and the results of SEM imaging show the thickness of the nanocomposite layer. As well as conductivity and electrical capacitance obtained through characterization using LCR meters which are 6.91218303 S/cm and 2.69 x10-10F.

Full Text:

PDF

References


Bhushan, B. 2007. Handbook of Nanotechnology . Ohio State University. Columbus USA. hal. 316.

Cabana J, Monconduit L, Larcher D, dan Palachin R. 2010. Beyond Intercalation‐Based Li‐Ion Batteries: The State of the Art and Challenges of Electrode Materials Reacting Through Conversion Reactions. Advanced Materials. Vol. 22 hal. E170–E192.

Can. M. M., Ozcan, S., Ceylan A., Firat. T.. 2010. Effect of Milling Time on The Synthesis of Magnetite Nanoparticles by Wet Milling. Materials Science and Engineering B, Vol. 172 (2010), hal. 72–75.

Choi, J.W dan Aurbach, D. 2016. Promise and reality of post-lithium-ion batteries with high energy densities. Nature Reviews Materials. Vol. 1. hal. 1-16.

Darvina, Y, Rianto, D, Murti, F, Yulfriska, N, Ramli. 2017. Struktur Nano Partikel Oksida Besi dari Pasir Besi Pantai Tiram Sumatera Barat. Prosiding Semirata Bidang Mipa.

Eken, A. E., Ozenbas, M. 2009. Characterization of nanostructured magnetite thin films produced by sol–gel processing. Journal Sol-Gel Sci Technol. 50:321–327.

Ge, Y, Jiang, H, Zhu, J, Lu, Y, Chen, C, Hu, Y, Qiu, Y, dan Zhang, X. 2015. High Cyclability of Carbon-Coated TiO2 Nanoparticles as Anode for Sodium-Ion Batterie. Electrochimica Acta, Vol. 157. hal. 142–148.

Giancoli, D.C. 2001. Fisika. Edisi Kelima. Jakarta : Erlangga.

Hidayat, A.S, Rokhmat, M., Qurthobi, A., 2014. Pengaruh Suhu dan Kecepatan Putar Spin Coating Terhadap Kinerja Sel Surya Organik Berbahan Dasar TiO2. Jurnal e- Procceding of Engineering. Vol.1. No.1 Desember 2014 hal.147. ISSN : 2355-9365.

House, V. E. and Ross, F., 2007, “Anode‟r‟ way” – Why the anode yields better

result, Altair nanotechnologies, (Altairnano) Inc.

Husain, J, Pradeep, P, Raghu, N, Yadwad, A.M, Kamblee, P, Reddy, N, Sagar, J, Anjum, B, and Prasad, M.N.V. 2016. Synthesis Conductivity and Sensitivity Studies of Polyaniline- Iron Oxide nanocomposites. Ferroelectrics 505. pp. 229–235.

Irzaman, A Maddu, H Syafutra, dan A Ismangil. 2010. Uji Konduktivitas Listrik Dan Dielektrik Film Tipis Lithium Tantalate ( LitaO3 ) Yang Didadah Niobium Pentaoksida (Nb2O5 ) Menggunakan Metode Chemical Solution Deposition. Prosiding Seminar Nasional Fisika 2010 ISBN : 978-979-98010-6-7.

Isac, L. Duta, A., Kriza, A., Manolache, S., Nanu, M. 2007. Copper Sulfides obtained by spray pyrolysis possible absorbers in solid-state solar cells. Journal Thin Solid Films, Elsevier.5755-5758.

Liu, C, Li, F, Ma, L-P, dan Cheng, H.M. 2010. Advanced Materials for Energy Storage. Advanced Materials. Vol. 22. Hal. E28-E62.

Prisma, A.J.P., Djoko, D.J. H.S., dan Masruroh. 2014. Pengaruh Konsentrasi dan Viskositas Larutan Polistirene terhadap Morfologi Permukaan dan Ketebalan Lapisan ZnPc pada Permukaan QCM. Jurnal fisika Universitas Brawijaya.

Ramli, Hartono, A., Sanjaya, E., Aminuddin, A., Khairurrijal, Haryanto, F., Imawaan, C., Djamal M. 2016. A Novel Ternary CoFe2O4/CuO/CoFe2O4 as a Giant Magnetoresistance Sensor. Journal Mathematical and Fundamental Sciences Vol. 48, No. 3, 230- 240

Ramli, Jonuarti, R., Hartono, A. 2017 Analisis Struktur Nano dari Lapisan Tipis cobalt Ferrite Yang Dipreparasi dengan Metode Sputtering. Eksakta Vol. 18 No. 1.

Riaz, S., Ashraf, Robina, Akbar, A., Nassem, S.2014. “ Free Growth of Iron Oxide Nanostructures by Sol-Gel Spin Coating Tchnique-Structural and Magnetic Properties.” Jurnal IEE Transactions On Magnetics. Vol 50 No.8 Agustus 2014

Rohman, Fadli. 2012. Aplikasi graphene untuk baterai Litium ion. Jurnal ITB Bandung.

Rohman, M., Subagio, A., Studi Karakteristik Kelisstrikan Komposit Karbon Nanotube-Polyvinilidene-Flouride (CNT-PVDF). Youngster Phyics Journal.Vol.1 No.3, April 2013 Hal 35-40.

Rustami, S. 2008. Sistem Kontrol Kecepatan Putar Spin Coating Berbasis Mikrokontroler ATmega8535. Jurnal Fisika IPB.

Shinde.V.R et. al. 2007. “Studies on growth of ZnO thin films by a novel chemical method”. Solar energy Material & Solar Cell. 91, 1055-1061.

Subhan, A., dan Prihandoko, B. 2011. Pembuatan Komposit Anoda Li4Ti5O12 dan Soda Lime Silica. Jurnal Ilmu Teknologi TELAAH,Vol. 29, 27-36 Mei 2011.

Susana, H, dan Astuti. 2016. Pengaruh Konsentrasi LiOH terhadap Sifat Listrik Anoda Baterai Litium Berbasis Karbon Aktif Tempurung Kemiri. Jurnal Fisika Unand. Vol. 5. No 2 ISSN 2302-8491.

Wigayati, E.M., Pembuatan Dan Karakterisasi Lembaran Grafit untuk Bahan Anoda pada Baterai Padat Lithium. Jurnal Fisika Himpunan Fisika Indonesia, Vol.9 No.1 , 70-78 Juni 2009.

Zhou, X, Dai, Z, Liu, S, Bao, J, dan Guo, Y.G. 2014. Ultra-Uniform SnOx/Carbon Nanohybrids toward Advanced Lithium-Ion Battery Anodes. Advanced Materials. Vol. 26. hal. 3943–3949.




DOI: http://dx.doi.org/10.24036/4644171074