Carbon Monoxide Measuring System using MQ-7 Sensor with Cloud Storage

Irfan Zaqi - Department of Physics, Universitas Negeri Padang, Jl. Prof. Dr. Hamka Air Tawar Padang 25131
- Yohandri - Department of Physics, Universitas Negeri Padang, Jl. Prof. Dr. Hamka Air Tawar Padang 25131
- Yulkifli - Department of Physics, Universitas Negeri Padang, Jl. Prof. Dr. Hamka Air Tawar Padang 25131
Nofi Yendri Sudiar - Department of Physics, Universitas Negeri Padang, Jl. Prof. Dr. Hamka Air Tawar Padang 25131

Abstract


Carbon monoxide (CO) gas cannot be detected by sight or smell but is highly detectable and is formed from incomplete combustion such as in motor vehicles. Currently monitoring CO gas levels and measurement data at any time cannot be accessed all the time. Therefore, a measuring instrument system with data storage is required. We developed an instrument to measure CO gas levels in the air. The system developed uses the MQ-7 and ESP8266 sensors to produce a CO gas level measurement device with Cloud Storage. This research is a type of engineering research. The measurement technique used is a direct and indirect measurement. The direct measurement technique is done by comparing CO level data from standard tools with measuring instruments. Indirect measurement techniques are carried out by analyzing the data. Based on the research objectives, the specifications of the work tools are the average accuracy percentage of 97.27%, and the precision of 97.31%. Based on these result, the CO gas level measuring tool has a measurement accuracy and precision of close to 100%. So it is concluded that the CO level measuring tool can work properly

Full Text:

PDF

References


M. Greenstone and Q. (Claire) Fan, “Kualitas udara Indonesia yang memburuk dan dampaknya terhadap harapan hidup,” Air Qual. Life Index, pp. 1–10, 2019.

M. Y. Harahap, R. A., & Hariyawan, “Rancang Bangun Alat Monitoring Kualitas Udara Berbasis NodeMCU ESP8266 (Hardware),” Appl. Bus. Eng. Conf., pp. 837–846, 2021.

S. K. Sarungallo, I. G. P. Raka Agung, and L. Jasa, “Rancang Bangun Alat Ukur Uji Emisi Gas Karbon Monoksida (CO) Berbasis Mikrokontroler,” Maj. Ilm. Teknol. Elektro, vol. 16, no. 1, p. 141, 2016.

A. Mutmainnah, “Pengembangan Alat Monitoring Kadar Gas Karbon Monoksida (Co) Berbasis Internet of Things,” 2021.

A. Rivanda, “Pengaruh Paparan Karbon Monoksida Terhadap Daya Konduksi Trakea,” J. Major., vol. 4, no. 8, pp. 153–159, 2015.

Y. D. Diken, I. wisnu Wardhana, and E. Sutrisno, “Analisis Dampak Kualitas Udara Karbon Monoksida (Co) Di Sekitar Jl. Pemuda Akibat Kegiatan Car Free Day Menggunakan Program Caline4 Dan Surfer (Studi Kasus: Kota Semarang),” J. Tek. Lingkung., vol. 6, no. 1, pp. 1–11, 2017.

S. A. N.H, “Analisis Konsentrasi Karbon Monoksida (Co) Pada Ruang Parkir Ayani Mega Mall Kota Pontianak,” J. Teknol. Lingkung. Lahan Basah, vol. 5, no. 1, pp. 1–10, 2017.

S. Jadoon, S. Nawazish, Q. Mahmood, A. Rafique, S. Sohail, and A. Zaidi, “Exploring Health Impacts of Occupational Exposure to Carbon Monoxide in the Labour Community of Hattar Industrial Estate,” Atmosphere (Basel)., vol. 13, no. 3, pp. 1–15, 2022.

M. B. Manurung, D. Darmawan, and R. F. Iskandar, “Perancangan Alat Ukur Karbon Monoksida (CO) Pada kendaraan Berbasis Sensor MQ7,” vol. 16, no. 103, p. 2042, 2018.

N. Kobbekaduwa, W. R. De Mel, and P. Oruthota, “Calibration and Implementation of Heat Cycle Requirement of MQ-7 Semiconductor Sensor for Detection of Carbon Monoxide Concentrations,” Adv. Technol., vol. 1, no. 2, 2021.

K. S. Babu and D. C. Nagaraja, “Calibration of MQ-7 and Detection of Hazardous Carbon Mono-oxide Concentration in Test Canister,” Int. J. Adv. Res. Ideas Innov. Technol., vol. 4, no. 1, pp. 18–24, 2018, [Online]. Available: https://www.ijariit.com/manuscript/calibration-of-mq-7-and-detection-of-hazardous-carbon-mono-oxide-concentration-in-test-canister/.

E. C. Fauzi, “Monitoring Kadar Karbon Monoksida dalam Mobil Dengan Sensor Mq-9 Bebrbasis Arduino,” vol. II, no. Lcd, pp. 10–14, 2021.

P. T. Dirgantara, S. Tinggi, and T. Kedirgantaraan, “Rancangan Purwarupa Pendeteksi Gas Karbon Monoksida ( Co ) Pada Pesawat Tanpa Awak Secara Nirkabel Berbasis,” vol. 8, no. 2, pp. 214–219.

M. A. A. Prakoso and L. Rakhmawati, “Sistem Monitoring Kadar Karbon Monoksida (CO) pada Cerobong Asap Industri dengan Komunikasi Bluetooth Melalui Smartphone Android,” J. Tek. Elektro, vol. 7, no. 1, pp. 23–30, 2018.

J. Rajagukguk and R. A. Pratiwi, “Emission Gas Detector ( EGD ) for Detecting Vehicle Exhaust Based on Combined Gas Sensors Emission Gas Detector ( EGD ) for Detecting Vehicle Exhaust Based on Combined Gas Sensors,” 2018, doi: 10.1088/1742-6596/1120/1/012020.

L. Kirkup, Experimental methods for science and engineering students: an introduction to the analysis and presentation of data, 2nd edition, vol. 61, no. 2. Cambridge University press, 2019.

H. F. A. Prabowo, M. Facta, and A. Nugroho, “Analisis Resonant Trafo Step Up Dengan Penyearah Ct Dan Jembatan Penuh,” Transform. Inductor Des. Handbook, Fourth Ed., vol. 4, pp. 1–8, 2015.

Yohandri, Mikrokontroler dan Pemrograman, Firs Edit. 2021.

Y. Parihar, Sing, “Internet of Things and Nodemcu: A review of use of Nodemcu ESP8266 in IoT products,” J. Emerg. Technol. Innov. Res., vol. 6, no. 6, pp. 1085–1086, 2019, [Online]. Available: https://www.researchgate.net/profile/Yogendra-Singh-Parihar/publication/337656615_Internet_of_Things_and_Nodemcu_A_review_of_use_of_Nodemcu_ESP8266_in_IoT_products/links/5e29767b4585150ee77b868a/Internet-of-Things-and-Nodemcu-A-review-of-use-of-Nodemcu-ES.

A. Adriansyah and O. Hidyatama, “Rancang Bangun Prototipe Elevator Menggunakan Microcontroller Arduino Atmega 328P,” J. Teknol. Elektro, vol. 4, no. 3, 2013, doi: 10.22441/jte.v4i3.753.

M. Jamil and M. Said, “The Utilization of Internet of Things (IoT) for Multi Sensor Data Acquisition using Thingspeak,” VOLT J. Ilm. Pendidik. Tek. Elektro, vol. 3, no. 1, p. 13, 2018, doi: 10.30870/volt.v3i1.1962.

M. Nnamdi, “Monitoring Health Using IoT and Thingspeak Monitoring Health Using IoT and Thingspeak,” no. December 2020, 2021.

S. Pasha, “Thingspeak Based Sensing and Monitoring System for IoT with Matlab Analysis,” Int. J. New Technol. Res., vol. 2, no. 6, pp. 19–23, 2016.

G. Hamdi and Krisnawati, “Membangun Aplikasi Berbasis Android ‘Pembelajaran Psikotes’ Menggunakan App Inventor,” J. DASI Vol. 12 No. 4 DESEMBER 2011, vol. 12, no. 4, p. 28, 2011.

D. Anggarani, M. Rahardjo, and N. Nurjazuli, “Hubungan Kepadatan Lalu Lintas Dengan Konsentrasi Cohb Pada Masyarakat Berisiko Tinggi Di Sepanjang Jalan Nasional Kota Semarang,” J. Kesehat. Masy., vol. 4, no. 2, pp. 139–148, 2016.




DOI: http://dx.doi.org/10.24036/13451171074