1. Home
  2. Vol 7, No 4 (2019)
  3. Ikbar

PERANCANGAN INVERTER MASTS DENGAN MONITORING KECEPATAN MENGGUNAKAN SENSOR HALL BERBASIS ARDUINO

Mhd Ikbar(1), Zulwisli Zulwisli(2),
(1) Universitas Negeri Padang  Indonesia
(2) Universitas Negeri Padang  Indonesia

Corresponding Author


DOI : https://doi.org/10.24036/voteteknika.v7i4.106464

Full Text:    Language : id

Abstract


The use of Brushless Direct Current Machines (MASTS) is very much applied in the industrial world compared to other types of drive engines. For the MASTS drive a three-phase inverter is needed, a three-phase inverter is a circuit that is used to convert DC voltage into AC voltage with a certain frequency. The system used to control the inverter is to use Pulse Width Modulation (PWM), where the pulse width is used to regulate the speed. To optimize the MASTS rotation speed, it is necessary to make speed monitoring to determine the stability of the MASTS speed, so design is carried out by combining the monitoring of the MASTS speed with a three-phase inverter. This tool uses a hall sensor, Arduino, and liquid crystal display (LCD) display. The working principle of the hall sensor is detecting the rotation speed of the MASTS based on the working principle of the electromagnetic hall sensor. In this study, 5 variations of PWM potentiometer inputs 20%, 40%, 60%, 80%, 100% were used to determine the results of monitoring of the MASTS speed for each input variation. In this study, an error rate of 6.2% was observed..

 

Keywords: Sensor Hall, SMATS, Inverter, RPM      

References


Jani, Yashvant. Implementing Embedded Speed Control for Brushless DC Motor. San Jose: Renesas Technology America, Inc.

Negi, Ankit. Tachometer Using Arduino and Hall Effect Sensor. Agust 13, 2017, http://engineerexperience.com/tachometer-using-arduino.html.

Fraden, Jacob. 1996. The Hand Book of Modern Sensor. California: Thermoscan, Inc.

Kadir, Abdul. 2013. Panduan Praktis Me- mpelajari Mikrokontroler dan Pemrogram- annya Menggunakan Arduin. Yogyakarta: Andi

Nanda Redha Arsya, Heri Suryoatmojo, Sjamsjul Anam Desain Control Kecepatan Motor Brush- less DC Berbasis Power Factor Correction (PFC) Menggunakan Single Ended Primery Inductance Converter (SEPIC). Jurnal Teknik ITS.2016

Adnan Mohammad, Md. Anwarul Abedin, Md. Zianurrahman khan. Implementation OF a Three Phasee Inverter For BLDC Motor Drive. 2016

Sutedjo, Ony Asrul Qudsi, Suhariningsih. Desain dan Implementasi Six-Step Com- unication Pada Sistem Kontrol Motor BLDC 1,5 kW. 2017

Samsul Arifin, Akhmad Fatoni. Pemanfaatan Pulse Width Modulation Untuk Mengontrol Motor (Studi Kasus Robot Otomatis Dua Devina). Agustus 2014

Sutedjo, Budi. Algoritma & Teknik Pemrog- raman. Yogyakarta. Andi Offset, 2000.


Article Metrics

 Abstract Views : 397 times
 PDF Downloaded : 196 times

Refbacks

  • There are currently no refbacks.